- Post-Processing
Welcome to Tinkerine Experiments. This episode will be talking about post-processing and smoothing out our PLA prints with Methylene Chloride.
Welcome to Tinkerine Experiments. This episode will be talking about post-processing and smoothing out our PLA prints with Methylene Chloride.
COMMENTS
Welcome to Tinkerine Experiments. This episode will be talking about post-processing and smoothing out our PLA prints with Methylene Chloride.
This seems to work well.
I would think that the rough textures on the bottom of the ring are from being set down in the lid of the mason jar. A way to alleviate that problem would be to "dip" the ring in the Methylene Chloride by hanging it from a wire. Then the wire is hung from a rack to dry the ring. Then the only part of the ring that is touched is the inside and only by a small diameter of wire.
Just a thought,
Jeff
Log in to join the conversation!
Log In